Pay in installments of $49.99 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours Β· Estimated delivery Jul 17 - Jul 22
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
MSD STAND ALONE RELAYClean up your wiring with an MSD Solid State High Current Relay Block. This high current module takes the place of 4 standard relays and eliminates unsightly wiring. Four independent channels can be activated using either power or ground. Each channel is capable of handling up to 35 Amps of continuous current, providing up to 140 Amps of power. It also has the capability of Pulse Width Modulation (PWM). With a PWM input, you can control the output at
Clean up your wiring with an MSD Solid-State High Current Relay Block. This high current module takes the place of 4 standard relays and eliminates unsightly wiring. Four independent channels can be activated using either power or ground. Each channel is capable of handling up to 35 Amps of continuous current, providing up to 140 Amps of power. It also has the capability of Pulse Width Modulation (PWM). With a PWM input, you can control the output at a rate of 15 hertz and a duty cycle of 50-90%. Controls electric fans, water pumps, nitrous solenoids, auxiliary lighting and any other electrical accessories that would normally require a relay. LED status indicators ensure proper wiring and operation of each channel. Should a problem arise, the relay block has built-in automatic over-temp, short circuit, and overload protection, as well as a channel reset. The solid-state high current relay can easily be mounted using the supplied hardware and mounting tabs that can be rotated 90Β° to accommodate various mounting locations. It's compact and clean design will make your wiring project a breeze.
Features:
- Operates from 7-Volts to 20-Volt supply
- 4 Independent Channels, 35 Amps each continuous or 100 Amps for 8 seconds
- Combined total continuous current rating of 140 amps
- Channels can be run in parallel for devices requiring more than 35 Amp single-channel rating
- Clean, easy install with minimum wiring
- Over-temp, short circuit and overload protection
- Diagnostic LEDβs and status indicators
- Multiple mounting options
- Single wire activation by switching power or ground
- Available in Red or Black
- A PWM signal can be used in the Solid-State Relay Module with a maximum frequency of 150 hertz and a duty cycle range from 50% to 90%.
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.8 β
β
β
β
β
Based on 15 reviews
Sort
Product Reviews
β
β
β
β
β
5
Good story
Format: Paperback
Awesome to see what happens right after episode 3
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on November 5, 2025
β
β
β
β
β
5
I love star wars
Format: Paperback
Yet, I love his comic book so much. I love Star Wars a lot too. I mean, this is a lot. This is a really cool comic. I love seeing dark vader fight like it's really cool
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 30, 2026
β
β
β
β
β
5
Vader's Second Marvel Series Is Good!
Format: Paperback
This is actually the start of a second Vader series. The first one began, along with the new Marvel main Star Wars series, right after the Death Star was destroyed. That Vader series birthed the new characters of Doctor Aphra, Triple Zero, BeeTee, and Cylo. Now, that series has come to an end.
THIS NEW SERIES IS GOOD!
It picks up the moment that Anakin Skywalker awakes in his armor at the end of Revenge of the Sith. It chronicles the first steps of Darth Vader.
We learn something new about the Sith. They do not create their own lightsabers. They must take a saber from a Jedi and make it their own.
The Sith blades are red and only red.
Why?
Palpatine explains that the kyber crystals that power the sabers are living things within the Force. This is backed up by the Rogue One novel (it was either that or Catalyst). The crystals are rock, but they are also alive.
In the hands of a Sith, the new owner uses the Dark Side to push all his pain into the crystal--until the crystal bleeds and turns the color of the beam red.
I just think that is all sorts of awesome!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 11, 2018
β
β
β
β
β
5
Vader when he still is Anakin
Format: Paperback
This comic picks up right where Episode III left off. Like directly. There's the whole "Noooooooooo" thing and everything. I liked seeing Vader when he is new to being a Sith. It really is Anakin under there still. Throughout the comic, that Anakin begins to fall away.
I liked the mix of prequel and original trilogy aesthetic. Seeing Vader alongside clone troopers was very cool. The Grand Inquisitor even makes a cameo!
I read the Dark Horse comics that took place right after Order 66 so certain aspects of this comic remind me of those. In this comic, there are jedi who took the Barash Vow prior to the Purge, so they are still out and about in the galaxy. Vader takes this opportunity to take a lightsaber and make it bleed.
I really enjoyed this first volume in a new, ongoing comic series. I am absolutely excited for volume two. I give this volume a 5/5.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on December 29, 2017
β
β
β
β
β
5
The Lord Vader Treatment
Format: Kindle
Love this Darth perspective. It potentially fills in some gaps in the timeline in the beginning of his transition. Loved the humor and the art.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 15, 2025
recommand products
SEA TO SUMMIT Aeros Ultralight Beluga Pillow
38.71
Contacta STS-K060 - Intercom slimline bridge bar system
1146.33
FS10-SR10F1-1C01W - Zebra FS10 Industrial Scanner: 1 MP, Standard Range, Fast 2D Barcode Decoder
636.50
TACENS MARS MCPU-X5 120 PWM 280W CPU cooler
38.38
Synology D4NS01-4G memory module 4 GB 1 x 4 GB DDR4
183.42